You can either set up this new “WSJT-X – ForEW1” from scratch with basic setting changes to get it to work or you can copy your settings from your “everyday” working copy of WSJT-X. Once a radio connection is established, the red will turn to green. This is normal because all “WSJT-X – ForEW1 settings” are defaulted and there is no radio connection yet. The red square means there is no radio connection. Notice the “N1MM-WSJT Radio Connection – 1” window in the middle of the screen. From the File menu, select “New Log in Database:” If you normally use Commander for WSJT-X, the Commander program should not be running when using “WSJT-X – ForEW1” and N1MM+ together.ġ. This is only a setting and Commander DOES NOT need to be installed on your PC. “WSJT-X – ForEW1” uses the setting “DXLab Suite Commander” to interface Radio Control from N1MM+.
#N1mm logger manual how to#
Instructions on how to do that are included in the Copy Settings from Everyday WSJT-X section. To save the pain of re-configuring the new instance of WSJT-X, it’s possible to copy all the settings of your “working instance” to the new instance. This new instance of WSJT-X is called “WSJT-X – ForEW1” and comes with all settings defaulted. Know that when you interface N1MM+ to WSJT-X, a new instance of WSJT-X is created that is completely separate from your working “everyday” copy. You should be able to use both programs independently before trying to link them together. Some basic knowledge of N1MM+ and WSJT-X is necessary. You must know the path to the location of WSJT-X on your hard drive. You must have a radio connected and configured in N1MM+. You should have the latest versions of N1MM+ and WSJT-X installed on your PC. (N1MMWSJTInstructions.pdf was written for an earlier version of N1MM+ but still gives valuable information.) In addition, more information can be found in the file “N1MMWSJTInstructions.pdf” located on the Additional Support Files page at. Read that document before following the instructions here. Official instructions for using the WSJT Decode List with N1MM+ are located at.
Putting “WSJT-X – ForEW1” in Contest Mode.Setting Up “WSJT-X – ForEW1” From Scratch.Starting “WSJT-X – ForEW1” For The First Time.In WSJT-X, you will need to setup the contest mode as shown here.) The rules for the FT Roundup are basically the same as the ARRL RTTY Roundup. (NOTE: this tutorial can also be used for the FT Roundup and ARRL RTTY Roundup by selecting ARRLRTTY as the “Log Type” in Step 2. Interfacing N1MM+ with WSJT-X for the WW Digi Contest by Don Hill, AA5AU
0 kommentar(er)
